Labfit Support | Knowledge Base

Recent Articles
Diagnostics not functioning
The problem when the [Diagnostics] or [Machine Interface] is not working is when there is a problem with the AD Card. The issue can be caused by the drivers for the AD Card are not present, they have been corrupted or the AD Card itself has faulted. ...
Pedestal purge has low flow to pedestal
Check that there is no blockage or leaks to the purge tubing. If a blockage has occurred, check the pedestal support plate purge inlet. In the event that there is a leak, check that the silicone tubing connecting the pedestal purge O2 to the ...
Syringe pump cavitation
Syringe pump cavitation (air bubbles in syringe during operation) can be caused by the following reasons; Aspiration line is too long. (Tubing going to reservoir) Syringe pump speed set too fast for the syringe size. Slow down the pump speed to a ...
Z Depth requires adjusting
You need to adjust the upper Z stop moving it upwards. Mark the bottom of the Z stop with a marker pen so that a visual representation can be observed when moving the Z stop. This will allow the probes to reach further into the sample cups. Test the ...
Replace Broken Pedestal
To install a new pedestal; Remove carousel Remove protective boot - rear of autosampler Remove 2 autosampler bay covers - left and right Unscrew old pedestal from pedestal support plate Screw new pedestal into pedestal support plate Repeat steps 3-1

Popular Articles
Analysis - Import Setup
Importing Your Samples There are only 9 available fields that can be imported into the program. The program only needs to set the formatting once, therefore once the formatting is complete the user will not be asked to format the file again. You can ...
Z Axis Constant Move Error
Adjust the Z Home sensor (Brass Ring) on probed holder. Make sure the magnet is aligned to within 5mm from the end or the front (where wires are) of the switch.
CS2000 Error Writing to File
Your IT department must fix the read/write permissions to your operating directory: Windows XP: C:\Program Files\CS2000 – Full access Windows 10 32 & 64 bit: C:\CS2000 – Full access Error occurs because the user account that is currently logged does ...
Calibration factor moved high
Very important that the operators change the Anhydrone at regular intervals. As the Anhydrone absorbs moisture, the occurrence that this is done is dependant on the dryness of the sample and also humidity that may enter the open tube combustion ...
Sample was heated, but result not measurable and not useable.
Make sure that the continue analysis on unstable result is checked in the global analysis settings. The results that are marked with an “X” can be output by turning on the [ok] (Bottom right column at bottom of screen) from the [Print Import\Format ...

Knowledge Base